HP XP20000/XP24000 Manual page 263

Table 52 Error Codes — Part Code 6010 (continued)
Part Error Error Message
Code Number
6010 65772 An external volume is
assigned to two or more
quorum disk IDs. An external
volume cannot be used for
multiple quorum disk IDs.
6010 65773 The serial number and the
controller ID of the RCU
registered in a quorum disk
do not correspond with the
specified RCU.
6010 65774 The serial number and the
controller ID of the RCU
registered in a quorum disk
do not correspond with the
information of RCU used by
the specified pair.
6010 65804 The quorum disk ID was not
specified. When the "Change
attribute to ESAM" parameter
has been changed from "No"
to "Yes", specify the quorum
disk ID.
6010 68753 An XP Thin Provisioning
volume is contained in the
selected volumes. This volume
cannot be used for XP
Continuous Access
Asynchronous or TrueCopy
Asynchronous for Mainframe.
6010 69018 There are two or more LDKC
numbers for the specified
data volume. In this
operation, specify only one
LDKC number.
6010 69022 There are no RCUs available.
Register RCUs in the CU or
RCUs of CU Free, and then
retry the operation.
6010 69023 There are no RCUs available.
To create pairs that have
different CU numbers
coexisting in the pair, register
RCU of CU Free and retry the
operation.
To create pairs with RCU in
the CU, select the M-VOLs so
that different CU numbers do
not coexist in the M-VOLs,
and retry the operation.
6010 69033 Since the number of preview
data exceeded the maximum,
the excess data were
discarded. No more preview
data can be stored.
Recommended Action
Assign another external
volume not used in the
quorum disk IDs, and then
retry the operation.
Select an RCU and a quorum
disk ID that have the same
serial number and the
controller ID, and then retry
the operation.
Select the quorum disk ID
corresponding with the serial
number and the controller ID
of the RCU that is used by the
specified pair, and then retry
the operation.
Specify the quorum disk ID,
and retry the operation.
Select a volume other than an
XP Thin Provisioning volume
and retry the operation.
Check the LDKC number for
the specified data volume,
and specify only one LDKC
number.
Register RCUs in the CU or
RCUs of CU Free, and then
retry the operation.
To create pairs that have
different CU numbers
coexisting in the pair, register
RCU of CU Free and retry the
operation.
To crate pairs with RCU in the
CU, select the M-VOLs so that
different CU numbers do not
coexist in the M-VOLs, and
retry the operation.
Click [OK]. Apply the
Preview data to the disk
storage system, and then
retry the operation.
Remote Web Console Error Codes 263
Severity Failure
Level Level
W 0
W 0
W 0
W 5
W 0
W 0
W 0
W 0
W 0