HP XP20000/XP24000 Manual page 284

Table 54 Error Codes — Part Code 6505 (continued)
Part Error
Code Number
6505 58277
6505 58278
6505 58279
6505 58280
6505 58281
6505 58282
6505 58283
6505 58284
6505 58285
6505 58286
284 Remote Web Console for Storage System Messages and Error Codes
Error Message
The specified secondary data
volume is not registered in the
specified journal group.
The specified restore journal
group is not registered.
The emulation type of the
specified secondary data
volume and the restore
journal volume is incorrect
due to one of the following
reasons:
The emulation type is not
supported.
The combination of
emulation types within the
journal group is incorrect.
The combination of the
emulation types of the
journal volumes of the
master and restore journal
groups is incorrect.
The emulation types of the
primary and secondary
data volumes are not the
same.
The specified secondary data
group is already registered.
No more pairs can be
registered in the specified
restore journal group.
The specified secondary data
volume is already registered
in another journal group.
The specified secondary data
volume cannot be deleted
because the volume is
already registered in another
journal group.
An internal error occurred.
No more pairs can be
registered because the
number of pairs will exceed
the maximum.
The command was rejected
because the command was
issued to the primary data
volume. The command is
supposed to be issued to the
secondary data volume.
Recommended Action
Check data volumes in the
specified secondary journal
group.
Check the status of the
specified restore journal
group.
Check the emulation type of
the specified secondary data
volume or the restore journal
volume.
Check the status of the
specified secondary data
volume.
Check the number of pairs in
the specified restore journal
group.
Identify the journal group
where the specified
secondary data volume is
registered.
Identify the journal group
where the specified
secondary data volume is
registered.
Call HP technical support.
Check the number of pairs.
Check the command
parameters.
Severity Failure
Level Level
i 0
i 0
i 0
i 0
i 0
i 0
i 0
E 4
i 0
i 0