HP XP20000/XP24000 Manual page 376

Table 64 Error Codes — Part Code 7105 (continued)
Part Error
Code Number
7105 8593
7105 8594
7105 8595
7105 8596
7105 8597
7105 8598
7105 8599
7105 8600
7105 8601
7105 8602
7105 8605
7105 8606
376 Remote Web Console for Storage System Messages and Error Codes
Error Message
The S-VOL is a source volume
for Auto LUN.
The S-VOL is a target volume
for Auto LUN.
The specified S-VOL does not
exist.
The specified volume is a
reserved volume.
The command has been
rejected, because the number
of pairs created with the
specified S-VOL has reached
the maximum.
The specified volume is not
an S-VOL.
The specified volume is
already an S-VOL.
The RAID level of the
specified volume is not
supported.
The specified S-VOL cannot
be paired with a backup
server volume.
The command has been
rejected, because the
specified S-VOL has already
been used as a T-VOL of the
other pair.
The Resync command was
issued to a device in the
simplex status.
The operation to create L2
pair has been rejected,
because the S-VOL of L1 pair
is used as the M-VOL of
TrueCopy for Mainframe
pair.
Recommended Action
Release the XP Auto LUN
setting.
Release the XP Auto LUN
setting.
Refresh, and then retry the
operation.
Check the status of the
volume
Pairs cannot be created with
the specified S-VOL any
more. See the Add Pair
Operation section in the
Hitachi ShadowImage™ for
Mainframe User's Guide: HP
XP24000 Disk Array, HP
XP20000 Disk Array for the
composition of pairs.
Check the status of the
volume
Specify other P-VOL, and
retry the operation. Or delete
the pair of the specified
volume, and then retry the
operation.
Check the RAID level, and
specify a volume of the
supported RAID level, and
then retry the operation.
Check the contents, and retry.
The volume used as a T-VOL
of the other pair cannot be
used as an S-VOL.
Check the pair status.
When the S-VOL of L1 pair is
used as the M-VOL of
TrueCopy for Mainframe
pair, L2 pair cannot be
created.
Severity Failure
Level Level
i 0
i 0
i 0
i 0
W 5
i 0
i 0
i 0
i 0
W 5
i 0
W 5