HP XP20000/XP24000 Manual page 53

Table 10 Error Codes — Part Code 01 10 (continued)
Part Error Error Message
Code Number
01 10 9105 The value that is under setup
is not reflected yet. Do you
want to exit?
01 10 9106 The value that is under setup
is not reflected yet. Do you
want to change the mode?
01 10 9107 The value that is under setup
is not reflected yet. Do you
want to continue the
operation?
01 10 55045 The installation status of
program products has been
changed. To update the
status immediately, select the
[Refresh] button.
01 10 55604 There are no valid program
products. Contact the storage
administrator and request to
allocate the license of SLPR.
01 10 56503 The unsupported JRE version
is used. Install the supported
version of JRE, and then retry
the operation.
01 10 56558 Modify mode released due
to inactivity. Another user or
service engineer may have
changed the configuration
while the Modify mode was
released. Get back to the
Modify mode and change the
configuration again. Set the
"RMI time-out period for
Modify" by using the "Set
Env." dialog box located on
the Control Panel of the
Remote Web Console to
change the time-out period
for Modify mode.
01 10 5701 1 An error occurred regarding
screen display. Log off from
Remote Web Console. After
that, please log on to Remote
Web Console again and
check whether configuration
changes have been made
correctly.
01 10 58580 The configuration information
is incorrect. Call HP technical
support.
Recommended Action
To close the window, click
[OK]. To not close the
window, click [Cancel].
To change the mode, click
[OK]. To not change the
mode, click [Cancel].
To continue processing, click
[OK]. To stop processing,
click [Cancel].
To update the status
immediately, click [Refresh].
Contact the storage
administrator and request to
allocate the license of SLPR.
Install the supported version
of JRE.
Return to the Modify mode
and change the configuration
again.
Log off from Remote Web
Console. Then log on to
Remote Web Console again
and check whether
configuration changes have
been made correctly.
If configuration changes have
been made correctly, there is
no problem.
If configuration changes have
been made incorrectly, retry
the operation.
If this problem persists, call
HP technical support.
Remote Web Console Error Codes
Severity Failure
Level Level
i 0
i 0
i 0
i 5
E 1
E 1
E 7
E 2
E 1
53