HP XP20000/XP24000 Manual page 403

Table 67 Error Codes — Part Code 8105 (continued)
Part Error Error Message
Code Number
8105 1203 High Speed mode/MIX mode
was specified. However,
there are addresses to which
High Speed mode/MIX mode
cannot be set in the Fibre
Addresses of the specified
ports.
8105 1204 High Speed mode/MIX mode
was specified. However,
there are topologies to which
High Speed mode/MIX mode
cannot be set in the
topologies of the specified
ports.
8105 1350 Add path to the initiator port
failed.
8105 1351 The high-speed or
initiator/external mix mode
cannot be set to the specified
port because of the attribute
of the port.
8105 1352 Logical paths remain on the
Fibre-MCU port. This
operation may cause a fatal
damage to the logical paths.
Please stop this operation. If
you want to continue this
operation, please remove the
logical paths from the MCU
port first.
8105 1353 S-VOLs remain on the
Fibre-RCU port. This
operation may cause a fatal
damage to S-VOLs. Please
stop this operation. If you
want to continue this
operation, please remove the
S-VOLs from the RCU port
first.
8105 1354 Failed to add the WWN to
the initiator port.
8105 1355 The host mode of the host
group connected to the
Initiator port cannot be
changed.
Recommended Action
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The port you are trying to set
is for XP Continuous Access.
You must change the attribute
(Target or RCU Target) when
adding a path.
Cannot set to high-speed
mode because the port
attributes are mixed, or
cannot set to
internal/external mix mode
because the combination of
port attributes is different.
Check the port attributes, and
then retry the operation.
Because the port you are
trying to set is for XP
Continuous Access, you must
delete the logical path, and
then retry the port setting.
Because the port you are
trying to set is for XP
Continuous Access, you must
delete the S-VOL logical path
that is set to RCU Target, and
then retry the port setting.
The port you are trying to set
is for XP Continuous Access.
You must change the attribute
(Target or RCU Target) when
adding a WWN.
The port you are trying to set
is for XP Continuous Access.
You must change the attribute
(Target or RCU Target) when
adding a WWN.
Remote Web Console Error Codes 403
Severity Failure
Level Level
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6