HP XP20000/XP24000 Manual page 334

Table 58 Error Codes — Part Code 6610 (continued)
Part Error
Code Number
6610 9122
6610 9127
6610 9128
6610 9155
6610 9303
6610 9305
6610 9306
6610 9308
6610 9309
6610 9327
6610 9332
6610 55036
6610 55037
6610 55038
334 Remote Web Console for Storage System Messages and Error Codes
Error Message
Are you sure you want to
export pair status?
Are you sure you want to
close all active graphs?
The specified volume was not
found.
The history file has been
updated. Select the OK
button to display the history
logs from the beginning.
There are no valid volumes.
There are no initiator ports.
The Universal Replicator for
Mainframe function is not
installed in this controller.
You cannot create pairs.
You set the same path more
than once. The duplicate
paths are excluded.
All paths which you set have
already been registered. This
operation will terminate
because there is no path
which can be added.
The monitoring time is over,
but the history file is not fully
updated yet.
This operation is not applied
yet.
Too many data volumes in
the journal group.
Too many mirrors in the
journal group.
Too many mirrors in the
subsystem.
Recommended Action
To export, click [OK]. To
cancel the operation, click
[Cancel].
To close the graphs, click
[OK]. Otherwise, click
[Cancel].
Click [OK], and then specify
the correct volume.
Click [OK].
Click [OK], and then specify
the correct volume.
Set the port to Initiator before
registering the storage
system.
Obtain a license for Universal
Replicator for Mainframe,
and then install it.
Because there are duplicated
paths in the added paths, the
duplicated paths will be
eliminated. Click [OK] to
continue.
Because all the added paths
are redundant, the paths
cannot be added. Click [OK]
and continue.
Click [Refresh] to update the
history file. If this problem
persists, call HP technical
support.
Click [OK], and then continue
the operation.
Check the number of data
volumes in the journal group.
Then delete unused data
volume pairs, or register them
in another journal group.
Check the number of mirrors
in the journal group. Then
delete unused mirrors, or
register them in another
journal group.
Check the number of mirrors
in the journal group, and
then delete unused mirrors.
Severity Failure
Level Level
i 0
i 0
i 0
i 0
W 0
W 0
W 5
W 0
W 0
i 0
i 0
i 0
i 0
i 0