HP XP20000/XP24000 Manual page 223

Table 50 Error Codes — Part Code 6005 (continued)
Part Error Error Message
Code Number
6005 8739 NVS status of MCU is not
active.
6005 8740 NVS status of RCU is not
active.
6005 8741 The logical paths between the
MCU and RCU are not
established.
6005 8742 Pinned track(s) exists on the
M-VOL.
6005 8743 Pinned track(s) exists on the
R-VOL.
6005 8744 The specified M-VOL
condition is not valid for XP
Continuous Access.
Recommended Action
The MCU NVS status
specified by the host is not
active. Set the NVS to on for
the MCU, using any attached
host, and then retry the
operation.
The RCU NVS status specified
by the host is not active. Use
any attached host to set the
NVS to on for the MCU, and
then retry the operation.
Check the path status
between the MCU and the
RCU.
Check the status of the
M-VOL tracks, and clear the
pinned tracks.
Check the status of the R-VOL
tracks, and clear the pinned
tracks.
The M-VOL is not available
for the requested operation,
because of one or more of
the following reasons:
The volume is blocked.
The volume is under
maintenance.
The volume is copying
data (correction copy or
drive copy).
The volume is correction
access condition.
Check the logical device
status of the specified M-VOL.
If the M-VOL is either under
maintenance or copying
data, retry the operation after
the process is completed.
Remote Web Console Error Codes 223
Severity Failure
Level Level
i 4
i 4
i 4
W 4
W 4
W 4