HP XP20000/XP24000 Manual page 72

Table 16 Error Codes — Part Code 0405 (continued)
Part Error
Code Number
0405 8003
0405 8202
0405 8203
0405 8204
0405 8205
0405 8206
0405 8301
0405 55263
0405 55506
0405 55520
0405 56508
72 Remote Web Console for Storage System Messages and Error Codes
Error Message
The subsystem status is
invalid. Call HP technical
support.
The DKCMAIN microcode
does not support this program
product.
This program product needs
a later version of hardware.
Call HP technical support.
To use the program product,
it needs to be enabled by
installing additional shared
memory.
This program product remains
in the configuration. Call HP
technical support.
This program product is in
use, you cannot uninstall this
program.
The subsystem status is
invalid. Call HP technical
support.
The specified program
product cannot be
uninstalled, because the
license for it is allocated to
the SLPR.
Since the licensed capacity
of SLPR0 is insufficient, the
partition capacity can't be
increased.
It is not possible to install it
because of PP of pre-install.
A license key code which
had been already deleted
was installed.
Recommended Action
Isolate the abnormal section
following the procedure
below:
1. Rebooting the computer.
If this does not fix the
problem:
2. Checking the LAN
card/LAN cable. If this
does not fix the problem:
3. Checking the IP address
of the computer. If this
does not fix the problem:
4. Replacing the computer.
If a new computer does
not fix the problem:
5. Turn the DKC on, and then
off (care should be taken.)
Contact HP technical support
for the plans of the program
product to be supported by
DKCMAIN.
Call HP technical support.
Install additional shared
memory and enable the
program product.
Call HP technical support.
Stop using this program
product function.
Retry this operation.
Delete the allocated license
from the SLPR, and then
uninstall the program
product.
Check the licensed capacity
of SLPR0.
If this problem persists, call
HP technical support.
Install the program product
by using another license key
code.
Severity Failure
Level Level
E 2
E 2
E 2
E 2
E 2
W 5
E 2
W 6
E 6
E 3
E 5