HP XP20000/XP24000 Manual page 370

Table 64 Error Codes — Part Code 7105 (continued)
Part Error
Code Number
7105 8501
7105 8502
7105 8503
7105 8504
7105 8505
7105 8506
7105 8507
7105 8508
7105 8509
7105 8510
370 Remote Web Console for Storage System Messages and Error Codes
Error Message
The command has been
rejected, because the
previous command is being
processed.
You cannot reserve the
volume, because a XP
Continuous Access pair exists
in the same subsystem frame.
You cannot create the new
pair, because a XP
Continuous Access pair exists
in the same subsystem frame.
The command was rejected.
Check the composition, the
status, or the volume status of
the pair.
The command has been
rejected, because the
operation cannot be accepted
in the current pair status.
The command has been
rejected, because the
specified T-VOL or reserved
volume is used by the host.
The Split Pair command was
issued to the pairs in the split
status.
The AddPair command was
issued to the pairs in the Split
status.
The Split command with the
QUIESCE specification was
issued to a secondary boot
device.
The M-VOL Suspend
command was issued to a
secondary boot device.
Recommended Action
Wait until the previous
operation completes.
Delete the XP Continuous
Access pair.
Delete the XP Continuous
Access pair.
Confirm the composition, the
status, or the volume status of
the pair. (See the Hitachi
ShadowImage™ for
Mainframe User's Guide: HP
XP24000 Disk Array, HP
XP20000 Disk Array for the
relationship between the
composition of the pair, status
of the pair, or the volume
status of the pair and those
operations.)
See the Adding Pairs and
Pair Status sections in the
Hitachi ShadowImage™ for
Mainframe User's Guide: HP
XP24000 Disk Array, HP
XP20000 Disk Array for the
relationship between the
status of pairs and the
commands that can be
accepted.
Check the contents, and retry.
Vary the T-VOL or the
reserved volume offline from
the mainframe host, and then
issue the command again.
You cannot execute the
AddPair operation to the
pairs in the Split status.
Check the contents, and retry.
Check the contents, and retry.
Severity Failure
Level Level
W 5
i 0
i 0
i 0
E 5
i 0
i 0
i 0
i 0
i 0