HP XP20000/XP24000 Manual page 230

Table 50 Error Codes — Part Code 6005 (continued)
Part Error
Code Number
6005 8803
6005 8804
6005 8805
6005 8806
6005 8807
6005 8808
230 Remote Web Console for Storage System Messages and Error Codes
Error Message
Too many RCUs in this CT
Group.
Copy mode cannot be
changed.
CT Group is not active in the
RCU.
CT Group Option cannot be
changed unless deleting or
suspending all asynchronous
pairs in the group.
Too many MCUs in this CT
Group.
Retry Add Pair
(Paircreate)/Resume Pair
(Pairresync) operation in a
few minutes.
Recommended Action
The add pair operation failed
because there are too many
RCUs in this CT group. If the
timer type is None, and then
4 RCU have already been
added. If the timer type is
Local or System, and then 1
RCU has already been
added. Check configuration
of CT group numbers already
used on both MCU and RCU.
Register a new CT group.
The resume pair operation
failed. The volume and the
copy mode must be either
both asynchronous or both
synchronous. Verify that the
status of the volume and the
copy mode match, and then
retry the operation.
The resume pair operation
failed, because there is no
R-VOL in the CT Group.
Verify the status of the CT
group in the MCU/RCU. If an
M-VOL exists, delete it and
retry the add pair operation.
To change the CT group
option (timer type or time
out), either delete all
asynchronous pairs in the
group, or verify the status of
the RCU CT Group option
and set the same option as
the MCU.
The add pair operation failed
because there are too many
MCUs in this CT group. If the
timer type is System, and then
4 MCUs have already been
added. If the timer type is
local or none, and then 1
MCU has already been
added. Register a new CT
group.
The add/resume pair
operation failed, because the
either the specified volume or
another volume in the same
group is being changed to
simplex or suspend status.
Retry the operation after the
status change is completed.
Severity Failure
Level Level
i 4
i 4
i 4
i 4
i 4
i 4