HP XP20000/XP24000 Manual page 221

Table 50 Error Codes — Part Code 6005 (continued)
Part Error Error Message
Code Number
6005 8714 An internal error occurred.
6005 8715 Invalid number of paths.
6005 8717 Invalid Destination Link
Address.
6005 8718 The specified logical path
already exists.
6005 8719 Invalid RCU serial number,
SSID, Link Address or
Controller ID.
6005 8720 Too many RCUs. (Four RCUs
are the maximum)
6005 8721 Path not completely
established.
6005 8722 Failure during path creation.
6005 8723 The Edit Path operation was
rejected because the
specified path is the last path
of some XP Continuous
Access pairs.
6005 8724 Specified number of paths is
less than the minimum
specified on RCU Option
screen.
6005 8725 Current microprogram
version does not support the
specified operation.
6005 8727 The number of minimum
paths exceeds the number of
normal paths.
Recommended Action
Call HP technical support.
The specified number of
paths is not within the
acceptable path range of 0
to 4. Verify the number of
paths and retry the operation.
The specified logical address
must be either 00 or 01.
Check the logical address
and retry the operation.
The specified link address
and port are already in use.
Check all existing logical
path addresses, and specify
another link address or RCP
port.
Check the serial number,
SSID, link address and
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, contact HP
technical support.
A maximum of four RCUs are
permitted, and that many
already exist.
Check the path connections
between the MCU and the
RCU, and then retry the
operation.
Check the path connections
between the MCU and the
RCU, and then retry the
operation.
Add another path, or delete
all pairs on the RCU. Then
retry the operation.
The specified number of
paths is less than the
minimum number of paths
specified on the RCU Option
window.
The version of the microcode
on the storage system does
not support the specified
function or operation. Call HP
technical support.
Add the normal paths, and
then set the minimum number
of paths.
Remote Web Console Error Codes 221
Severity Failure
Level Level
E 4
E 4
E 4
i 4
E 4
i 4
E 4
E 4
i 4
i 4
i 4
i 4