HP XP20000/XP24000 Manual page 164

Table 37 Error Codes — Part Code 3205 (continued)
Part Error
Code Number
3205 8971
3205 8978
3205 56513
3205 56514
3205 56516
3205 56517
3205 56519
3205 56520
3205 67764
3205 68735
164 Remote Web Console for Storage System Messages and Error Codes
Error Message
Failed to update the
configuration information.
Call HP technical support.
An error occurred on the
DKC side. If this problem
persists, call HP technical
support.
The specified emulation type
is the type that cannot be
added. To set the specified
emulation type, the cache
segment size must be
changed. Call HP technical
support.
The capacity of the specified
volume is less than the
minimum required to perform
the Add LU operation.
The configuration of XP
Continuous Access is defined.
Reset the configuration
definition of XP Continuous
Access, and then retry the
operation.
The Business Copy,
ShadowImage for
Mainframe, Compatible
FlashCopy(R), or XP Snapshot
setting exists. Release the
setting and then retry the
operation.
The reserve volume setting of
Business Copy,
ShadowImage for
Mainframe, Compatible
FlashCopy(R), or XP Snapshot
exists. Release the reserve
volume setting and then retry
the operation.
The reserved volume setting
of Auto LUN is defined.
Release the reserved volume
setting of Auto LUN, and then
retry the operation.
The number of XP Thin
Provisioning volumes (TP-VOL)
that can be defined in one
V-VOL group is just one.
A volume used as System
Disk is included in the items
to be maintained.
Recommended Action
Reboot the SVP computer,
and retry the operation. If this
problem persists, call HP
technical support.
An error occurred on the
DKC side. If this problem
persists, call HP technical
support.
Check the emulation type. To
change the cache segment
size to set the specified
emulation type, call HP
technical support.
Check the capacity of the
volume.
Reset the configuration
definition of XP Continuous
Access, and then retry the
operation.
Release the setting of XP
Business Copy,
ShadowImage for
Mainframe, FlashCopy
Mirroring, or XP Snapshot,
and then retry the operation.
Release the reserve volume
setting of XP Business Copy,
ShadowImage for
Mainframe, FlashCopy
Mirroring, or XP Snapshot,
and then retry the operation.
Release the reserved volume
setting of XP Auto LUN, and
then retry the operation.
Check the setting.
Restore the blockage status
of the system disk. If the status
cannot be restored, call HP
technical support.
Severity Failure
Level Level
E 2
E 3
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5