HP XP20000/XP24000 Manual page 145

Table 34 Error Codes — Part Code 3005 (continued)
Part Error Error Message
Code Number
3005 65650 The specified volume is used
as a System Disk volume.
3005 65659 The specified volume is used
as an XP Thin Provisioning
volume.
3005 65671 The pool volumes associated
with the XP Thin Provisioning
volume is included in the
items to be maintained.
Release the association of the
pool volume and the XP Thin
Provisioning volume included
in the items to be maintained.
3005 65675 The LDEV to be operated is
not included in the specified
parity group. Check the
setting and the status of the
LDEV in the specified parity
group.
3005 65676 The association cannot be
made because the pool is in
a different CLPR.
3005 65677 The association cannot be
released because paths are
defined to the target volumes.
3005 65678 The association cannot be
released because a LUSE
setting is made on the target
volumes.
3005 65679 The association cannot be
released because the target
volumes are reserved for Auto
LUN.
3005 65680 The operation failed because
some V-VOL groups cannot
be associated or released.
3005 65688 A failure occurred while
formatting.
3005 65689 A failure occurred while
quick formatting.
3005 65690 The specified volumes contain
volumes that are being quick
formatted. Check the settings
and retry the operation.
3005 65691 Preparing for quick format.
Check the status and wait
until the status changes to a
status that maintenance is
possible.
Recommended Action
Check the setting of the
specified volume.
Check the setting of the
specified volume.
Release the association of the
pool volume and the XP Thin
Provisioning volume included
in the items to be maintained.
Check the setting and the
status of the LDEV in the
specified parity group.
Confirm that it is associated
with a pool in the same CLPR.
Release the paths, and then
retry the operation.
Release the LUSE setting, and
then retry the operation.
Make sure that the volumes
are not reserved for XP Auto
LUN, and then retry the
operation.
Associate or release LDEVs in
the V-VOL groups.
Cancel the format processing
from the SVP, and then retry
the formatting processing
again.
Cancel the quick formatting
processing from the SVP, and
then execute the quick
formatting processing again.
Check the settings and retry
the operation.
Check the status and wait
until the status changes to a
state that allows
maintenance.
Remote Web Console Error Codes 145
Severity Failure
Level Level
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
W 6
E 2
E 2
E 6
E 6