HP XP20000/XP24000 Manual page 184

Table 40 Error Codes — Part Code 4005 (continued)
Part Error
Code Number
4005 58514
4005 58709
Table 41 Error Codes — Part Code 4010
Part Error
Code Number
4010 1030
4010 1032
4010 2080
4010 5010
4010 501 1
184 Remote Web Console for Storage System Messages and Error Codes
Error Message
Currently running microcode
version does not support the
specified operation.
A maintenance operation is
in progress. For example:
LDEV formatting is in
progress
Correction Copy is in
progress
Drive Copy is in progress
The CHA/DKA status is
changing
The cache status is
changing
Replacement of an OEM
drive microprogram is in
progress
LDEV shredding is in
progress
Extent shredding is in
progress
Therefore the specified
operation cannot be
executed.
Error Message
Part of the range is already
in use.
The specified value is outside
the valid range.
Prestaging not completed.
The value specified as the
ending address for the data
to be placed in cache is
smaller than the value
specified as the starting
address.
The value specified as the
Number of Cache Residency
areas is equal to or less than
one cylinder.
Recommended Action
Call HP technical support.
Wait a few seconds, and
then retry the operation.
Recommended Action
Correct the specified content,
and issue the request again.
Correct the specified content,
and issue the request again.
Wait a few seconds, click
[Refresh], and change the
same configuration again. Or
if the DKC status is not
blocked, check the DKC
status. If the same error
occurs, call HP technical
support.
Correct the values specified
as the starting and ending
addresses, and then retry the
operation.
Correct the specified content,
and retry.
Severity Failure
Level Level
E 2
W 6
Severity Failure
Level Level
i 0
i 0
E 6
W 5
W 5