HP XP20000/XP24000 Manual page 441

Table 87 Error Codes — Part Code 9605 (continued)
Part Error Error Message
Code Number
9605 58448 The specified logical volume
is blocked, or the LDEV is
being formatted or shredded.
9605 58449 The capacity of the logical
volume is not the same as
that of the external volume
with which the logical volume
is mapped.
9605 58450 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
9605 68002 This logical volume cannot be
selected because it is used as
a volume for System Disk.
Table 88 Error Codes — Part Code 9610
Part Error Error Message
Code Number
9610 7060 An error occurred during
processing. If this problem
persists, call HP technical
support.
9610 7442 There is an invalid value in
the Data Retention Utility
information.
9610 81 12 There is no valid volume.
9610 9107 The value that is under setup
is not reflected yet. Do you
want to continue the
operation?
9610 9362 Do you want to change the
expiration lock mode?
9610 9363 The specified retention term
exceeds the maximum.
Recommended Action
Retry the operation after the
logical volume has recovered
from the blocked status or
after the LDEV has been
formatted or shredded.
Do one of the following:
1. Execute the Volume
Initialize operation on the
external group to which
the logical volume belongs
in the Customized Volume
window, and create a
volume having the same
capacity as the external
volume.
2. Execute the Make Volume
operation on the external
group to which the logical
volume belongs in the
Customized Volume
window, and create a
volume having the same
capacity as the external
volume.
If this problem persists, call
HP technical support.
Check the logical volume
configuration, and then retry
the operation.
Recommended Action
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
Mount volumes, and then
retry the operation.
To continue processing, click
[OK]. To stop processing,
click [Cancel].
To change the mode, click
[OK]. Otherwise, click
[Cancel].
Correct the retention term,
and then retry the operation.
Remote Web Console Error Codes 441
Severity Failure
Level Level
E 5
E 5
E 5
E 5
Severity Failure
Level Level
E 2
E 3
W 6
i 0
i 0
i 0