HP XP20000/XP24000 Manual page 108

Table 26 Error Codes — Part Code 1005 (continued)
Part Error
Code Number
1005 1 135
1005 1 136
1005 1 137
1005 1 138
1005 1 140
1005 1 170
1005 1 174
1005 1 177
1005 1 178
1005 1 180
1005 1 181
108 Remote Web Console for Storage System Messages and Error Codes
Error Message
An error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
Failed to form a LUSE volume
because the number of LUSE
volumes exceeds the
maximum that can be set in
a disk array subsystem.
An error occurred. If this
problem persists, call HP
technical support.
Because the Port Group
setting is done, it is
impossible to change.
Release the Port Group
setting.
The volume cannot be
configured as a command
device because the volume
does not have Read/Write
attribute.
The specified host ID is
already registered.
The specified host is already
registered.
An incorrect host name was
specified.
An error occurred. If this
problem persists call HP
technical support.
The specified path cannot be
added, because the volume
is used by a XP Continuous
Access pair.
Recommended Action
When PORT information
(Fibre Address/Fibre
Topology/Channel Speed) is
set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
When CHA high-speed mode
is set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
An error occurred. If this
problem persists, call HP
technical support.
Release the Port Group
setting.
Correct settings, and then
retry.
Correct the settings, and then
retry.
Correct the settings, and then
retry.
Correct the settings, and then
retry.
If this problem persists call HP
technical support.
Correct the specification, and
then retry the operation.
Severity Failure
Level Level
E 2
E 2
E 6
E 2
E 2
E 6
E 6
E 6
E 6
E 2
W 6