HP XP20000/XP24000 Manual page 250

Table 50 Error Codes — Part Code 6005 (continued)
Part Error
Code Number
6005 68796
6005 68812
6005 68813
6005 68816
6005 68817
6005 68826
250 Remote Web Console for Storage System Messages and Error Codes
Error Message
The operation failed. The
operation cannot be
accepted in the pair status of
the specified volume.
A pair could not be created
because the specified R-VOL
was an XP Thin Provisioning
volume whose capacity was
being changed.
A pair could not be created
because the specified M-VOL
was an XP Thin Provisioning
volume whose capacity was
being changed.
A pair cannot be created
because the specified volume
is used as a primary data
volume of the XP Continuous
Access Journal.
The specified R-VOL was a
pair volume of the XP
Continuous Access Journal.
A pair could not be created
because "Cylinder" was set
to the "Difference
Management".
The operation failed, because
the External Storage function
was not installed.
Recommended Action
Refresh the window, and
confirm the pair status of the
specified volume.
Check each capacity of the
M-VOL and the R-VOL after
the capacity change of R-VOL
ends, and plan a
combination of volumes for
pair creating.
Check each capacity of the
M-VOL and the R-VOL after
the capacity change of
M-VOL ends, and plan a
combination of volumes for
pair creating.
The specified volume is a
primary data volume of XP
Continuous Access Journal,
which runs on the 2DC
configuration in which XP
Continuous Access or XP
External Storage Access
Manager cooperates. Specify
another volume.
The RCU runs on the 2DC
configuration in which the XP
Continuous Access Journal
cooperates.
Set Track to the Difference
Management, and then retry
the operation.
Install XP External Storage,
and then retry the operation.
Severity Failure
Level Level
W 0
W 0
W 0
W 0
W 0
W 0