HP XP20000/XP24000 Manual page 367

Table 63 Error Codes — Part Code 7010 (continued)
Part Error Error Message
Code Number
7010 5121 The data has been changed.
If you select another tab
(page), the settings will be
discarded. Are you sure you
want to continue?
7010 5122 No data has been changed.
7010 5123 The password is invalid.
7010 5124 You cannot select more than
one operation at a time.
7010 5125 No target volume is selected.
7010 5126 You cannot create another L2
pair, because the number of
L2 pairs exceeds the
maximum.
7010 5127 The specified MU number is
invalid. Select another MU
number.
7010 6504 The number of L1 pairs
exceeds the maximum.
7010 6505 The number of L2 pairs
exceeds the maximum.
7010 7310 Unregistered error code.
7010 731 1 The settings could not be
applied.
7010 7312 The password could not be
acquired.
7010 7313 Error details not available.
7010 7440 An error occurred during
processing. If this problem
persists, call HP technical
support.
7010 8534 An internal logic
contradiction occurred.
7010 8658 Some settings could not be
applied normally. See the
error code.
7010 8659 The PCB required for this
operation is not mounted.
Check the subsystem
configuration.
Recommended Action
Apply the data in the Preview
List. To stop the transaction,
click [OK] and continue the
operation.
Go on to the next operation.
Check the password.
Multiple volumes cannot be
processed in the operation.
Process one volume at a time.
Select the target volume.
You cannot create L2 pair for
the specified P-VOL. Delete
the created L2 pair, and retry
the operation.
Select the other MU number.
You cannot create L1 pair for
the specified P-VOL. Delete
the created L1 pair, and retry
the operation.
You cannot create L2 pair for
the specified P-VOL. Delete
the created L2 pair, and retry
the operation.
Call HP technical support.
Wait a few seconds, and
retry the operation. If the
error occurs after retrying,
call HP technical support.
Call HP technical support.
Call HP technical support.
If this problem persists call HP
technical support.
Call HP technical support.
Check the error code in the
Preview list.
Mount the required PCB, and
then retry the operation.
Remote Web Console Error Codes 367
Severity Failure
Level Level
W 0
W 0
W 0
W 0
W 0
W 0
i 0
i 0
i 0
E 0
W 0
E 0
E 0
E 2
E 0
E 0
i 5