HP XP20000/XP24000 Manual page 381

Table 64 Error Codes — Part Code 7105 (continued)
Part Error Error Message
Code Number
7105 8920 Because a L1 pair is F-Copy,
you cannot operate to L2.
7105 8941 The command was rejected
because the specified CT
Group is already used.
7105 8942 The CT Group operation is
not available because the
target DKC microprogram
version does not support the
CT Group operation.
7105 8946 A pair status cannot be
changed because the Split
time of Consistency Group is
set.
7105 8991 The command has been
rejected, because the
FlashCopy Mirroring V2
relationship exists.
7105 8992 The command has been
rejected, because sufficient
amount of shared memory is
not installed.
7105 8993 The command has been
rejected, because the shared
memory is not set for
FlashCopy Mirroring V2.
7105 8994 The command has been
rejected, because the storage
system is busy.
7105 8995 The command has been
rejected, because the
FlashCopy Mirroring V2
relationship exists.
7105 8996 The command has been
rejected, because the storage
system is busy.
7105 55645 Quick Restore cannot be
executed because the
specified pair is composed of
the external volumes with
different cache mode settings.
7105 56301 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
7105 56302 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
Recommended Action
Wait for Flash Copy
processing of a L1 pair being
finished, and then execute
operation of target pair.
Correct the specified CT
Group and retry the
operation again.
Install the appropriate version
of DKC microcode.
Reset the Split time of
Consistency Group from the
mainframe host.
Withdraw the FlashCopy
Mirroring V2 relationship.
Install additional shared
memory.
Set the shared memory
extension setting for
FlashCopy Mirroring V2.
Wait a few seconds, and
retry the operation.
Withdraw the FlashCopy
Mirroring V2 relationship.
Wait a few seconds, and
retry the operation.
Use the Reverse Resync
option.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
Remote Web Console Error Codes 381
Severity Failure
Level Level
i 0
i 0
i 0
i 0
W 0
E 0
E 0
W 0
W 0
W 0
W 5
E 2
E 2