HP XP20000/XP24000 Manual page 385

Table 64 Error Codes — Part Code 7105 (continued)
Part Error Error Message
Code Number
7105 58575 An error occurred while
connecting to the subsystem.
Wait for a while, and then
retry the operation.
7105 58585 The operation failed because
the CU group of the specified
volume is not supported.
7105 58630 The operation failed because
the specified S-VOL was used
by Delta resync of Universal
Replicator for Mainframe.
7105 58631 The operation failed because
the specified T-VOL was used
by Delta resync of Universal
Replicator for Mainframe.
7105 58632 The reserve volume setting
failed because the specified
volume was used by Delta
resync of Universal Replicator
for Mainframe.
7105 68743 The command has been
rejected, because Quick
Format is performed on the
specified S-VOL.
7105 68744 The command has been
rejected, because Quick
Format is performed on the
specified T-VOL.
7105 68745 FICON(R) Data Migration
Source Volume is specified as
a T-VOL. FICON(R) Data
Migration Source Volume
cannot be used as a T-VOL.
7105 68746 The command has been
rejected because the pair
uses FICON(R) Data
Migration Source Volume.
Recommended Action
If this problem persists, call
HP technical support.
Volumes that do not belong
to CU group 0 are currently
not supported. Specify
another volume.
The command cannot be
executed with the current
status of the Universal
Replicator for Mainframe
pair. See the Interoperability
with Other Products and
Functions section in the
Hitachi ShadowImage™ for
Mainframe User's Guide: HP
XP24000 Disk Array, HP
XP20000 Disk Array for the
relationship between the state
of Universal Replicator for
Mainframe pair and the
ShadowImage for Mainframe
operations.
The P-VOL of Universal
Replicator for Mainframe pair
for Delta resync cannot be
specified as an S-VOL.
Specify another volume.
The P-VOL of Universal
Replicator for Mainframe pair
for Delta resync cannot be
specified as a reserved
volume. Specify another
volume.
Retry the operation after the
Quick Format has completed.
Retry the operation after the
Quick Format has completed.
FICON(R) Data Migration
source volume cannot be
used as a T-VOL. Use other
volumes.
The specified pair cannot be
operated because the pair
uses FICON(R) Data
Migration source volume.
Remote Web Console Error Codes 385
Severity Failure
Level Level
E 6
i 0
W 5
W 5
W 5
i 0
i 0
i 0
i 0