HP XP20000/XP24000 Manual page 267

Table 54 Error Codes — Part Code 6505 (continued)
Part Error Error Message
Code Number
6505 8706 Parameter specified by XP
Continuous Access operation
is invalid.
6505 8708 The pair status of the
secondary data volume is
incorrect.
6505 8709 XP Continuous Access
operation was rejected.
6505 8710 The pair status of the
specified data volume is
incorrect.
6505 871 1 The specified parameter is
incorrect.
6505 8712 The operation was rejected
due to a FREEZE state.
6505 8713 The port group already exists
on the specified port.
6505 8714 An internal error occurred.
6505 8715 The number of paths is
incorrect.
6505 8719 The serial number or the
controller ID of the remote
subsystem is incorrect.
6505 8720 The number of registered
remote subsystems already
reached the maximum (that
is, 64).
Recommended Action
Enter the correct data.
Refresh the window, and
check the pair status. If
possible, retry the operation
on the secondary data
volume.
Replace the channel adapter,
and then retry the operation.
Refresh the window, and
check the pair status of the
pair. If the pair status can be
manipulated, retry the
operation.
Check the port number, ID,
and LUN of the storage
system.
If you are performing a path
operation, retry the operation
after the FREEZE status is
released.
If you are performing a pair
operation, check the DKC
status, wait until the SCP time
elapses, and then retry the
operation.
Exchange the port type after
deleting the group setting.
Call HP technical support.
Ensure that the number of
paths is correct, and then
retry the operation. If the
problem persists, call HP
technical support.
Check the serial number and
the controller ID of this remote
storage system and already
registered remote storage
systems, and then specify the
correct values.
If the specified values are
correct, check the cable
connection of the remote
storage system. If the problem
persists, call HP technical
support.
Reduce the number of
registered remote storage
systems, and then retry the
operation.
Remote Web Console Error Codes 267
Severity Failure
Level Level
i 4
i 4
E 4
W 0
i 4
E 4
E 4
E 4
E 4
E 4
i 4