HP XP20000/XP24000 Manual page 369

Table 63 Error Codes — Part Code 7010 (continued)
Part Error Error Message
Code Number
7010 66102 Information was updated by
other users. The list will scroll
to the top.
7010 66560 The maximum number of
Pairs or Volumes that can be
displayed in the Preview List
is 16,384. Change the
number of pairs or volumes
being displayed in the
Preview List to 16,384 or
less.
7010 69025 Some pairs are excluded
from the pairs to be set,
because pairs in invalid
status for Pairsplit operation
or XP Snapshot pair is
included in the specified
pairs.
Table 64 Error Codes — Part Code 7105
Part Error Error Message
Code Number
7105 5099 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
7105 5625 An internal logic error
occurred.
7105 5626 The specified volume cannot
be used because it is
write-protected by Volume
Retention Manager.
7105 6502 Processing in progress. Please
wait for a while, and then
retry the operation.
7105 6503 The volume status is being
changed to simplex.
7105 6520 The command has been
rejected, because the
specified volume was
registered in the Security
Group that cannot specify
T-VOL or reserved volume.
7105 7310 This error code is not
registered.
7105 8500 Sufficient amount of shared
memory is not installed or the
program product is not
installed.
Recommended Action
Click [OK], and then continue
the operation.
Change the number of pairs
or volumes displayed in
Preview to 16,384 or less.
Change the status of the
excluded pair. Pairsplit
operation cannot be executed
from Remote Web Console,
if the specified pair is an XP
Snapshot pair.
Recommended Action
If this problem persists, call
HP technical support.
Call HP technical support.
Release the write-protection
by Volume Retention
Manager.
Wait a few seconds, and
retry the operation.
Wait a few seconds, and
retry the operation.
Execute one of the following:
Change the attribute of
the Security Group so that
the Security Group can
specify T-VOL or reserved
volume.
Remove the volume
specified from the Security
Group.
If this problem persists, call
HP technical support.
Add shared memory or
confirm whether the
necessary program product
key is installed.
Remote Web Console Error Codes 369
Severity Failure
Level Level
W 5
W 0
i 5
Severity Failure
Level Level
E 2
E 0
i 0
W 0
i 0
i 0
E 0
i 0