HP XP20000/XP24000 Manual page 106

Table 26 Error Codes — Part Code 1005 (continued)
Part Error
Code Number
1005 1 108
1005 1 1 10
1005 1 1 1 1
1005 1 1 16
1005 1 123
1005 1 125
1005 1 126
106 Remote Web Console for Storage System Messages and Error Codes
Error Message
The following volumes cannot
be specified when you
change the command device
configurations:
Volumes reserved by Auto
LUN
Volumes other than the
open-system volumes
(including unmounted
volumes)
System Disk volume
An error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
Command device security
cannot be set to the specified
volume because the volume
is not a command device.
There are no host groups
where the WWN will be
registered.
A volume set as a command
device cannot be used as a
component of a LUSE volume.
Select another volume.
Recommended Action
Check the setting, and then
retry the operation.
If this problem persists, call
HP technical support.
A nickname is not specified
when the configuration
change of LUN Manager is
requested. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
You have not specified the
value when registering
WWN. Or zero is set as the
WWN value. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Correct the specified contents,
and request again.
Severity Failure
Level Level
E 6
E 2
E 2
E 2
E 6
E 6
E 6