HP XP20000/XP24000 Manual page 433

Table 85 Error Codes — Part Code 9205 (continued)
Part Error Error Message
Code Number
9205 5041 The number of issued
commands exceeds the
maximum.
9205 551 1 The program product is not
installed.
9205 6012 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
9205 6023 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
9205 6038 The mistake is found in the
set parameter.
9205 6502 Processing in progress. Wait
for a while, and then retry the
operation.
9205 6533 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
9205 7060 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
9205 71 1 1 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
9205 7310 This error code is not
registered.
9205 8001 An error occurred while
connecting to the subsystem.
Retry a little later.
9205 8002 A communication time-out
error occurred in the
subsystem. Wait for a while,
and then retry the operation.
9205 8102 This function is not supported.
9205 8120 The specified logical volume
does not exist.
9205 8121 This logical volume is an
open volume.
9205 8122 This logical volume is busy.
Recommended Action
Reduce the number of set
demands.
Install the program product.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
Wait a few minutes, and then
retry the operation.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
Retry a little later.
Retry a little later.
Check whether the
DKCMAIN microcode version
and the SVP microcode
version are mismatched.
Specify a mainframe Volume.
Specify a mainframe Volume.
Retry a little later.
Remote Web Console Error Codes 433
Severity Failure
Level Level
W 5
W 5
E 3
E 3
E 3
W 5
E 3
E 2
E 3
E 5
E 3
E 3
E 3
E 5
E 5
E 5