HP XP20000/XP24000 Manual page 105

Table 26 Error Codes — Part Code 1005 (continued)
Part Error Error Message
Code Number
1005 1050 The following volumes cannot
be specified when you
change expanded LU
configurations:
Volumes reserved by Auto
LUN
1005 1059 An error occurred. If this
problem persists, call HP
technical support.
1005 1061 Security Switch Off operation
and path adding operation
cannot be performed
simultaneously. Check the
current configuration and
then make settings again.
1005 1063 The specified WWN is
already in use. Specify
another WWN.
1005 1064 You are trying to register the
same WWN as the already
registered one. Check the
settings and request the
setting of the configuration
information again.
1005 1065 The specified host name or
the host group name is
already registered. (The host
name and the host group
name cannot be the same.)
1005 1066 WWN number, which is not
registered, is specified.
(When deleting, or changing)
1005 1067 You are trying to register the
same host group number as
the already registered one.
1005 1068 The specified host group has
not been registered.
Recommended Action
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
You are trying to perform
LUN Manager operation for
non-Fibre port. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
First, add paths, and then
click Apply. Next, turn off the
security switch, and then click
Apply.
Correct the specified contents,
and request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Correct the specified contents,
and request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Remote Web Console Error Codes 105
Severity Failure
Level Level
E 6
E 2
E 6
E 6
E 6
E 6
E 6
E 6
E 6