HP XP20000/XP24000 Manual page 326

Table 56 Error Codes — Part Code 6510 (continued)
Part Error
Code Number
6510 59010
6510 5901 1
6510 59013
6510 59026
6510 59030
6510 59031
6510 59039
6510 59042
326 Remote Web Console for Storage System Messages and Error Codes
Error Message
WARNING:
Initial copy mode None is
selected for some volume
pair. Are you sure that the
primary data volume and the
secondary data volume of the
pair are already
synchronized?
Are you sure you want to
output the %s file?
The specified file already
exists. Do you want to
overwrite this file?
The same DKC is specified
more than once. Check the
DKC setting.
The monitoring data saved at
present will be deleted.
The monitoring data saved at
present will be deleted when
the monitoring switch is set to
Enable the next time.
You cannot add journal
volumes because XP
Continuous Access Journal is
not installed.
There are no valid journal
groups.
Recommended Action
Check the contents of the
primary and secondary
volumes. If the contents
match, click [Yes]. Otherwise,
click [No].
To output the file, click [Yes].
Otherwise, click [No].
To overwrite the file, click
[Yes]. Otherwise, click [No].
Check the DKC setting.
To continue the operation,
click [OK]. To cancel the
operation, click [Cancel].
The current monitoring data
will be deleted if you change
the setting of the monitoring
switch. If necessary, use the
Performance Monitor Export
Tool to export the monitoring
data file.
To continue processing, click
[OK]. To stop processing,
click [Cancel].
The monitoring data currently
saved will be deleted when
you change the setting of the
monitoring switch. If
necessary, use the Export
Tool to save the monitoring
data.
Purchase a license for XP
Continuous Access Journal,
and then install it.
All journal groups are used
by Universal Replicator for
Mainframe or XP Continuous
Access Journal. If possible,
delete journal groups of
Universal Replicator for
Mainframe or XP Continuous
Access Journal, and then start
the XP Continuous Access
Journal window or the
Universal Replicator for
Mainframe window.
Severity Failure
Level Level
W 0
i 0
W 0
W 0
i 5
i 5
W 0
W 0