HP XP20000/XP24000 Manual page 20

Table 3 Error Codes — Part Code 0003 (continued)
Part Error
Code Number
0003 1021
0003 1022
0003 1023
0003 1024
0003 1025
0003 1027
0003 1028
0003 1029
20 Remote Web Console for Storage System Messages and Error Codes
Error Message
An error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
The specified LU path does
not exist.
The specified value of the
command device setting is
invalid. Check the setting.
The number of volumes you
intend to combine into a
LUSE volume exceeds the
maximum.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
Recommended Action
The specified volume does
not exist. (You have specified
wrong CU#:LDEV#.) Or the
LDEV (exclusively for
mainframe) cannot be
processed in this agent. The
error does not occur normally
because it is guarded in the
screen. In the unlikely event
that this error occurs, contact
HP technical support.
Host mode is invalid. (The
specified value is not in the
specification.) The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
If this problem persists, call
HP technical support.
Fibre topology information is
invalid. (The specified value
is not in the specification.)
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
The specified value of the
command device setting is
invalid. (The specified value
is not in the specification.)
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
If this problem persists, call
HP technical support.
Severity Failure
Level Level
E 2
E 2
E 2
E 2
E 6
E 2
E 6
E 2