HP XP20000/XP24000 Manual page 437

Table 87 Error Codes — Part Code 9605 (continued)
Part Error Error Message
Code Number
9605 8120 The specified logical volume
does not exist.
9605 8122 This logical volume is busy.
9605 8123 This function is not supported.
9605 8124 This logical volume is a
mainframe volume.
9605 8125 The attribute of the logical
volume has been changed by
RAID Manager.
9605 8126 This logical volume is
configured as a command
device.
9605 8128 A parameter error occurred.
9605 8132 This error code is not
registered.
9605 8134 You cannot change the
attribute of this logical volume
to Read/Write. Call HP
technical support if you want
to change the attribute.
9605 8135 This logical volume is already
used as an S-VOL for XP
Continuous Access or
Business Copy.
9605 8136 The command was rejected,
because the licensed capacity
was exceeded.
9605 8138 The Reserved setting of the
specified volume cannot be
released. To release the
Reserved setting, call HP
technical support.
9605 8139 The specified volume is a
P-VOL for Business Copy.
9605 8141 This logical volume cannot be
selected because it is used as
a reserve volume for Auto
LUN.
9605 8142 You cannot select this logical
volume because it is used as
a XP Continuous Access
Journal volume.
Recommended Action
Specify an open-system
volume.
Retry a little later.
Check whether the
DKCMAIN microcode version
and the SVP microcode
version are mismatched.
Specify an open-system
volume.
Review LDEV information,
and then retry.
Check the logical volume
configuration, and then retry
the operation.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
You cannot change the
attribute of this logical device
to Read/Write. Call HP
technical support To change
the attribute.
Check the logical volume
configuration, and then retry
the operation.
The currently licensed
capacity is insufficient. To
increase the licensed
capacity, buy a new license
key.
The Reserved setting of the
specified device cannot be
released. To release the
Reserved setting, call HP
technical support.
Check the volume, and then
retry the operation.
Check the volume, and then
retry the operation.
Check the logical volume,
and then retry the operation.
Remote Web Console Error Codes 437
Severity Failure
Level Level
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5