HP XP20000/XP24000 Manual page 109

Table 26 Error Codes — Part Code 1005 (continued)
Part Error Error Message
Code Number
1005 1 182 An error occurred. If this
problem persists call HP
technical support.
1005 1 183 The port information is
inconsistent with PCB mode
information.
1005 1 184 The port information is
inconsistent with PCB mode
information.
1005 1 185 You are trying to insert in the
linkage operation including
LUSE. (LDEV number is
inserted to the LDEV numbers
created in LUSE).
1005 1 186 In the linkage operation
including LUSE, the path is
specified to other than the
top.
1005 1 187 You cannot expand the LU
because the host mode of the
group with paths which are
defined in the LU is
corresponding to online
LUSE.
1005 1 190 To define a path to the
volume from an iSCSI port,
the volume must be
read/write-enabled and also
usable as an S-VOL
(secondary volume).
1005 1 194 No information can be
changed about this external
port because the port has an
external volume.
1005 1 197 You cannot set high-speed
mode to a package including
an external port.
1005 1 198 Since a path is defined to an
external LU, you cannot set
high-speed mode.
1005 1 199 The path cannot be set to the
specified volume because the
volume is not an
open-systems volume.
1005 1201 The selection of High Speed
mode/MIX mode is invalid.
The specified port cannot be
changed to High Speed
mode/MIX mode.
Recommended Action
If this problem persists call HP
technical support.
Correct the port information
or the PCB mode information.
Correct the port information
or the PCB mode information.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Correct the settings, and then
retry the operation.
Correct the settings, and then
retry.
Correct the settings, and then
retry.
Correct the settings, and then
retry.
Check the setting.
Change the parameter to a
path where the High Speed
mode/MIX mode can be set,
and then retry the operation.
Remote Web Console Error Codes 109
Severity Failure
Level Level
E 2
W 0
W 0
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6