HP XP20000/XP24000 Manual page 325

Table 56 Error Codes — Part Code 6510 (continued)
Part Error Error Message
Code Number
6510 55229 You want to forcibly delete
pairs, but there are some
pairs where Group is not
specified as the range.
Specify Group as the range
when you want to forcibly
delete pairs.
6510 55644 [Warning]
There are some pairs where
Group is not specified as the
range in the pairs specified
to be deleted forcibly.
Other pairs in the same
group may suspend due to a
failure by this operation.
Are you sure you want to
delete pairs?
6510 56504 There is no journal group that
can be used as a master
journal group.
6510 56505 There are no secondary
subsystems available.
Register secondary
subsystems and then retry the
operation.
6510 56522 There are no consistency
groups available. Create
unused consistency groups
and then retry the operation.
6510 56523 No more mirrors can be
created for the specified
volume.
6510 59004 An error occurred. Check the
error details.
6510 59005 An invalid value is specified.
6510 59006 No more journal volumes can
be registered, or too many
volumes are selected.
6510 59007 Are you sure you want to
delete the specified
subsystems?
6510 59008 Are you sure you want to
delete the paths of the
specified subsystem?
6510 59009 Since the number of Preview
data exceeded the maximum,
the excess data were
discarded. No more Preview
data can be stored.
Recommended Action
Specify normal deletion, or
specify Group as the range.
To delete pairs, click [Yes].
Otherwise, click [No].
Register a journal group.
Register secondary storage
systems, and then retry the
operation.
There are no consistency
groups available. Create
unused consistency groups,
and then retry the operation.
Check the mirrors of the
specified volume.
Check the error information.
Specify the valid value.
Check the number of journal
volumes in the specified
journal group, or check the
number of the selected
volumes.
To delete the specified
storage system, click [OK].
Otherwise, click [Cancel].
To delete the specified path,
click [OK]. Otherwise, click
[Cancel].
Click [OK]. Apply the
Preview data to the disk
storage system, and then
retry the operation.
Remote Web Console Error Codes 325
Severity Failure
Level Level
W 0
W 0
W 0
i 0
i 0
i 0
i 0
i 0
i 0
i 0
i 0
i 0