Configuring Bootp On The Current Instance Of The Switch Or Server - Avaya 5900 Series Quick Start Configuration

Connecting and configuring the switch
Variable
width
Configuring BootP on the current instance of the switch or
server
About this task
The default operational mode for BootP on the switch is BootP or DefaultIP. The switch requests an
IP address from BootP only if one is not already configured from the console terminal (or if the IP
address is the default IP address 192.168.1.1).
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
ip bootp server {always | disable | last | default-ip}
Variable definitions
Use the definitions in the following table to use the ip bootp server command.
Variable
always | disable | last | default-ip
October 2015
Definition
Sets the width of the terminal display in characters.
By default, 79 characters are displayed.
DEFAULT: 79
Definition
Specify when to use BootP:
• default-ip—Use BootP or the default IP
• last—Use BootP or the last known address
• disable—Never use BootP
• always—Always use BootP
By default, default-ip is selected.
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
26