Performing a soft-start of the switch
Use this command to perform a soft-start of the switch.
Procedure
1. Logon to the Privileged EXEC mode in ACLI.
2. To perform a soft-start of the switch, enter the following command:
Variable definitions
The following table describes the parameters for the bootp command.
default
Configuring BootP on the current instance of the switch or server
Use this command to configure BootP on the current instance of the switch or server, as the
default ip, the last known address, never, or always.
Procedure
1. Logon to the Global Configuration mode in ACLI.
2. To configure BootP on the current instance of the switch or server, enter the
Variable definitions
The following table describes the parameters for the ip bootp server command.
Getting Started
boot [default]
Variable
following command:
[no] [default] ip bootp server {default-ip|last|disable|
always]
Setting boot parameters using ACLI
Value
Restores switch to factory-default settings
after restarting.
March 2013
63