Advertisement
DOORS
6-41
Fig. 6-53 — Front Door Hardware - " F " Styles
1. Inner Panel Cam Bolts
2. Lock Screws
3. Regulator Bolts
4. Remote Control Bolts
5. Ventilator Division Channel
Lower Stud and Nut
6. Window Rear Guide Bolts
3. With a flat-bladed tool, straighten out crimped-
over edges of lock cylinder housing scalp and
remove scalp and lock cylinder from housing.
4. To install, reverse removal procedure.
NOTE:
The lock cylinder housing scalp is
usually damaged in the removal procedure and,
therefore,
must be replaced.
Replacement
scalps are available as a service part.
FRONT DOOR VENTILATOR REGULATOR-
Manual and Electric-"B-C" Styles
Removal and Installation
1. With front door window in full-up position,
remove door trim assembly and partially de-
tach inner panel water deflector.
2. On Pontiac,
Oldsmobile
and Buick styles
equipped with electric ventilator regulators,
disconnect door wire harness at ventilator
Advertisement
