Advertisement
DOORS
6-73
1. Window Rear Guide Upper Bolts
2. Window Rear Guide Center
Adjusting Stud and Nut
Fig. 6-98 —Front Door Hardware - " E " Body Styles
3. Window Rear Guide Lower
Adjusting Stud and Nut
4. Inner Panel Cam
5. Rear Trim Pad
Adjusting
Plate
4. Remove regulator motor attaching bolts and
remove motor from regulator assembly (Fig.
6-97).
NOTE:
Clean off any steel chips from regu-
lator sector gear and motor pinion gear.
5. To install, reverse removal procedure. If dif-
ficulty is encountered in lining up motor at-
taching holes with regulator assembly, the
regulator lift arm may be moved into position
manually so that motor pinion gear will mesh
with teeth on regulator sector gear. After
installation of front door window assembly,
cycle electric regulator several times before
installing inner panel water deflector and door
trim pad.
NOTE:
Be sure to remove temporary nut and
bolt securing regulator back plate to regulator
sector gear before installing assembly into
door.
FRONT DOOR WINDOW REAR GLASS
RUN CHANNEL-"A-17-39 and 6 7 " Styles
Removal and Installation
1. Raise door window. Remove trim pad and de-
tach inner panel water deflector.
2. Remove front door window guide plate.
3. Remove run channel upper attaching bolt (lock
pillar) and lower adjusting stud nut (inner
panel - see Fig. 6-74 for "17" and "67"
Styles and Fig. 6-79 for "39" Styles).
4. Swing run channel down and forward and re-
move from door.
5. To install, reverse removal procedure.
NOTE:
For adjustments of rear run channel,
Advertisement
