Advertisement
REAR QUARTER
7-11
3. Remove glass run channel outer strip assembly
(draft strip - see "Door" index of manual).
4. Remove the lower two adjusting stud nuts of the
quarter window front guide and all but the top
attaching bolt of window regulator (see Fig.
7-27).
5. Rotate regulator counter-clockwise until lift
arm roller is free of quarter window sash
channel cam. Rotate rear edge of glass up-
ward (outboard of side rail on "11" styles) and
remove window (see Fig. 7-27).
NOTE:
If additional clearance is needed on
"17" styles, the side roof rail weatherstrip
can be detached at quarter window area.
6. To install, reverse removal procedure.
ADJUSTMENTS-"A-17 & 67" Styles
To perform any rear quarter window adjustments,
it is necessary to remove the rear quarter trim
assembly.
1. To adjust window "fore or aft", loosen front
Fig. 7-12-Rear Quarter Hardware - " F " Body Styles
1. Rear Quarter Window
2. Sash Channel Cam
3. Up-Stop
4. Window Guide
5. Regulator (Manual)
6. Regulator (Electric)
Advertisement
