Advertisement
STATIONARY GLASS
4-5
A LOCATION
B LOCATION
1193
Fig. 4-5—Glass Spacers
body metal more than 1/32", replace or re-
form the clip. Be sure reveal molding clip
screws are sealed.
3. If the original glass is to be re-used, remove
all remaining traces of old caulking material
with toluene or thinner dampened cloth.
4. Using black
weatherstrip adhesive, cement
three rubber spaces to lower windshield open-
ing at location "A", Figure 4-5.
5. Place
glass
in opening,
shim glass with
spacers as necessary to properly align glass
to opening. The glass should overlap the pinch-
weld flange 3/8". Mark glass to windshield
pillars with tape to assist in proper alignment
at time of installation (Fig. 4-6).
6. Apply 1" wide masking tape to inside of wind-
shield glass 1/4" inboard from edge of glass,
across the top and down each side, to facilitate
cleanup after installation.
7. Using a clean, lint-free cloth, briskly rub a
generous amount of adhesive caulking primer
on the freshly cut material in the opening.
CAUTION:
Do not allow primer to drop on
painted surfaces or trim.
8. Wipe surface of glass to which bead of ad-
hesive caulking material will be applied (be-
tween masking tape and edge of glass) with a
clean, water dampened cloth. Dry glass with
a clean dry cloth.
9. Apply a smooth continuous bead of adhesive
caulking material to inside surface of glass
next to edge completely around glass (Fig.
4-7).
Material should be 1/8" to 3/16" in
diameter.
IMPORTANT:
The
operation
of
installing
glass into the opening should be completed
within 15 minutes from start of application of
material to glass.
NOZZLE IN KIT
ADH__
CAULKING MATERIAL
1/8 TO 3 / 1 6
DIA. BEAD
TAPE VA
FROM EDGE
1288
Fig. 4-6—Glass Alignment
Fig. 4-7-Adhesive Caulking Material
Application - Short Method
Advertisement
