Advertisement
7-16
REAR QUARTER
RETAINER
SECTION B.B
SECTION C-C
VIEW I
VIEW II
1281
Fig. 7-20—Rear Quarter Window Glass Run Channels - Typical of all Closed Styles
A secondary glass stop is located in vertical
sash channel cam (see Fig. 7-11). This stop is
retained by a single bolt and is accessible
through lock pillar grille opening (see Fig.
7-32).
NOTE:
Major glass adjustment is available at
inner panel cam adjusting studs and nuts (see
Fig. 7-30). In addition, the glass run channel
rear attachment provides in or out and up or
down adjustment. Also, a glass lower stop is
attached to the rear plate of the glass run
channel. This stop is adjustable fore and aft.
D. REMOVAL AND INSTALLATION-
"F-37 & 67" Styles
3. Remove upper two nuts of front guide adjusting
studs (see Fig. 7-33).
4. Remove lock pillar sealing strip and glass run
channel outer strip assembly (belt seal). Re-
moval and installation of lock pillar sealing
strips is covered in the "Door" section of this
manual (see index). The outer belt seal is re-
tained by screws.
5. On "67" styles, pull window straight up and
remove from body. On "37" styles, remove
glass outboard of roof panel.
6. To install, reverse removal procedure.
1. Remove rear quarter window regulator assem-
bly (see index).
2. On convertible styles, lower folding top.
NOTE:
Figure 7-34 illustrates relationship of
window assembly to guide. Figure 7-35 illus-
trates all components of the rear quarter win-
dow assembly.
Advertisement
