Advertisement
7-22
REAR QUARTER
Fig. 7-33—Rear Quarter Window Hardware - " F " Styles
Window Up-Stop
Window Guide
Upper Adjusting
Stud and Nuts
3. Window Guide
Lower Adjusting
Stud and Nut
4. Window Regulator Bolts
4. To control the down-travel of the quarter win-
dow (fully lowered position), adjust the down
travel stop. The down stop is located in the
sash channel cam on "B-C 67" and "C-57"
styles ("5", Fig. 7-43), and in the front guide
on the remaining "B-C" hardtop styles as
shown in Figure 7-44.
REAR QUARTER WINDOW REGULATOR
(MANUAL OR ELECTRIC)-
"B-C 47-57-67-87" Styles
Removal and Installation
1. Remove rear quarter trim assembly. On "67"
styles remove inner panel access hole cover.
On "47-57-87" styles, remove inner panel
water deflector.
2. On "67" styles with electric window regula-
tors, disconnect wire harness at in-line con-
nector located inboard of inner panel. DO NOT
attempt to disconnect permanent connector at
motor. On "47-57-87" styles, disconnect wire
harness connector at motor.
3. If window regulator failed with window in full-
up position, proceed as follows:
a. Prop window in full-up position.
b. Remove window regulator attaching bolts
"6", (Fig. 7-43).
c. Disengage regulator lift arm roller from
lower sash channel cam at rear of cam and
remove regulator through access hole.
4. If regulator failed with window in full-down
position, proceed as follows:
a. Remove regulator attaching bolts "6" (Fig.
7-43).
b. Supporting window, move regulator forward
to disengage lift arm roller at front of
lower sash channel cam.
NOTE:
On styles with down stop in cam
("5", Fig. 7-43), remove stop prior to dis-
engaging regulator roller.
GLASS ROLLERS
GUIDE
2338
Fig. 7-34—Rear Quarter Window and Guide Assembly
" F " Styles
Advertisement
