Advertisement
15-24
SEATS
ADJUSTER
REAR NUTS
ADJUSTER FRONT BOLTS
CARPET RETAINER
GROUND
WIRE
2473
Fig. 15-26 —Bucket Seat Floor Pan Attachment -
" A , F, X & Z " Styles
seat adjuster components are the same as for the
standard full width front seat assembly - Refer to
the appropriate section under "Standard Seats'\
MANUALLY OPERATED BUCKET
SEAT ASSEMBLY
Removal and Installation
1. Operate seat to full rearward position.
2. Turn back floor carpeting sufficiently to ex-
pose seat adjuster-to-floor pan attaching nuts
or bolts (Fig. 15-26 and 15-27).
3. Operate seat to full rearward position. Remove
adjuster-to-floor pan front attaching bolts (Fig.
15-26 and 15-27). Operate seat to full forward
position. Remove adjuster-to-floor pan rear
attaching bolts and remove seat assembly from
body.
4. To install, reverse removal procedure. Check
operation of seat adjusters to full limits of
travel.
POWER OPERATED HORIZONTAL OR
FOUR-WAY BUCKET SEAT ASSEMBLY
The two-way and four-way (tilt) seat adjusters are
actuated by a 12 volt, reversible shunt wound motor
with a built-in circuit breaker.
The four-way seat adjuster operating mechanism
incorporates a transmission assembly which in-
cludes two solenoids and two drive cables leading
to the seat adjusters. One solenoid controls the
vertical movement of the seat while the other sole-
noid controls the horizontal movement of the seat.
When the control switch is actuated, the motor
drives the transmission by means of a belt and one
of the transmission solenoids are energized simul-
taneously. The solenoid plunger then engages with
the drive cables and operates both adjusters. When
the adjusters reach their limit of travel, the drive
cables stop their rotating action and torque is
absorbed by the rubber belt connecting the motor
and transmission. When the switch contacts are
opened,
a
return
spring returns the solenoid
plunger to its original position disengaging it from
the driving gear dog.
Removal and Installation
1. Operate seat to full forward position. On four-
way power seats operate seat to full up posi-
tion. Remove seat cushion side panels, where
present. Where seat adjuster track covers are
present, carefully pry out track cover snap-on
retainers with a flat-bladed tool and remove
track covers.
2. Where necessary, remove sill plates and turn
back floor carpeting to expose seat adjuster-
to-floor pan attaching nuts and bolts.
ADJUSTER NUTS
ADJUSTER
ADJUSTER ANCHO
PLATE STUDS
Fig. 15-27 —Manually Operated Bucket Seat
Pan Attachment - "B & C " Styles
Advertisement
