Advertisement
15-60
SEATS
EXISTING ROOF ANCHORAGE
MOUNTING PLATE
PLASTIC TRIM CAP
EXISTING ROOF
ANCHORAGE
-ROOF ANCHOR SCREWS'
-SHOULDER STRAP
ROOFANCHORAGE
All Styles Except Convertib les )
FLOOR ANCHORAGE
( W i t h CenterMount Seat Belts
2548
Fig. 15-84-Shoulder Strap Roof Anchorage (All Styles
except Convertible) and Floor Anchorage (All Styles)
REAR QUARTER ANCHORAGE-
Convertible Styles
Remove folding top compartment side trim upper
panel attaching screws. Remove convertible top
male hinge upper attaching bolt securing shoulder
strap anchor plate. (See Fig. 15-85). Carefully pull
compartment side trim upper panel away from rear
quarter trim sufficiently to remove shoulder strap
and protective sleeve from between panels. To in-
stall reverse removal procedure. Check that pro-
tective sleeve is properly positioned between
quarter and side trim panel.
FLOOR PAN ANCHORAGE-
AM Styles (See Fig. 15-84)
Remove anchor bolt securing shoulder harness
floor pan anchor plate (See Fig. 15-84 for styles
with center mount seat belts) (See Fig. 15-81 for
styles with side mount seat belts).
SHOULDER STRAP BUCKLE RETAINER-
AM Styles
To properly locate shoulder strap buckle retainers
for an original shoulder strap installation refer to
locating dimensions supplied in the service package
installation instruction sheets.
NOTE: Shoulder straps not in use must be
anchored by inserting buckle into retainer to
prevent buckle end from lashing about.
Removal and Installation
Carefully insert a small straight screw driver into
joint of retainer and open retainer to gain access
to retainer attaching screws (See Fig. 15-86). Re-
move retainer attaching screws (Fig. 15-86) and
remove retainer. To install, reverse removal
procedure.
Advertisement
