Advertisement
DOOR, QUARTER AND SHELF TRIM
14-27
VIEW • A
VIEW - B
Fig. 14-42—Compartment Shelf Center Trim Panel -
Cadillac " E " Styles
5. To remove compartment shelf trim panel from
shelf panel, pull panel forward and straight out.
6. To remove the center trim panel, bend metal
tabs (Fig. 14-42) to straight down position and
detach from center base panel.
7. To install, reverse removal procedure.
quarter
t r i m
assembly,
as previously
described.
3. Remove compartment shelf side finishing panel
attaching screws (Fig. 14-39) and remove side
finishing panel. On Oldsmobile styles, discon-
nect courtesy lamp feed wire.
4. To install, reverse removal procedure.
COMPARTMENT SHELF SIDE AND
CENTER TRIM PANELS-
Cadillac " E " Styles
The compartment shelf trim assembly consists of
four individual panels joined together with screws
to form a single unit. It is necessary to remove the
assembly to service the individual sections. The
assembly is retained with integral studs and nuts at
five locations. Additional retention is obtained using
bend-over metal tabs on the center trim section.
Removal and Installation
1. Remove rear seat cushion and rear seat back
assemblies as described under "Rear Seats".
2. Remove rear quarter trim assembly as de-
scribed under "Door and Rear Quarter Trim".
3. Remove back window lower garnish molding
and back window lower corner escutcheons.
4. Remove rear compartment side panel attaching
screws (View "A", Fig. 14-41). Loosen com-
partment shelf to metal foundation nuts as indi-
cated in View "C", Fig. 14-41. Remove center
section attaching nuts (View "A & B", Fig.
14-42 and View "B", Fig. 14-41).
Advertisement
