Advertisement
6-66
DOORS
Fig. 6-89 —Front Door Hardware - " B - C " Hardtop and Convertible Styles
Window Lower Sash Channel
3.
to Rear Guide
4.
Plate Bolts
5.
Inner Panel Cam
Attaching Bolts
Window Front Up-Stop
Window Rear Up-Stop
Rear guide Upper
Attaching Bolt
Rear Guide to Lower
Support Bracket Bolt
Ventilator Lower Frame
Adjusting Stud and Nut
8. Ventilator Division Channel
Lower Adjusting Stud
and Nut
9. Window Regulator Attaching Bolts
2. To adjust upper rear corner of window in-or-
out in relation to side roof rail weatherstrip,
loosen rear guide upper attaching bolt ("5",
Fig. 6-89) and position run channel farther in-
board. If this adjustment proves inadequate,
remove door trim pad and obtain additional
adjustment at one or both of the following:
a. Rear guide to lower support attaching bolt
("6", Fig. 6-89).
b. Ventilator front frame adjusting stud ("7",
Fig. 6-89).
Outboard adjustment at either of these loca-
tions tends to move the door window upper
rear corner inboard. Conversely, inboard
adjustment of either attachment moves the
top of the glass outboard.
To adjust window up-travel, operate window to
"full-up" position and loosen front and rear
upper stops ( " 3 " and " 4 " , Fig. 6-89). Operate
window to desired up position and tighten stop
bolts.
Advertisement
