Advertisement
6-64
DOORS
FRONT DOOR WINDOW
ADJUSTMENTS-"!" Styles
To adjust the front door window up or down, loosen
the front and rear up-travel stops and operate
window to desired position. Then, position and
tighten adjustable stops on sash channel against
welded-on stops on front and rear run channels.
To rotate the glass in the opening (lower or raise
front edge of glass) loosen the inner panel cam
attaching screws. Raise or lower adjustable end of
cam as required and tighten cam screws.
To adjust rear edge of glass in or out at the belt
line, loosen the rear glass run channel upper at-
taching screw (Fig. 6-87) and adjust the run channel
in or out as required.
To adjust the top edge of glass in or out in relation
to side roof rail, loosen lower adjusting stud nuts of
vent division channel and rear glass run channel
(Fig. 6-87). Adjust studs in or out as required,
then tighten stud nuts.
Slight fore and aft adjustment is available by ad-
justing the vent division channel and rear glass
run channel fore or aft at the lower adjusting stud
locations (Fig. 6-87).
REAR GLASS
RUN CHANNEL
UPPER BOLT
DOOR LOCK
SCREWS
REAR GLASS],
RUN CHANNEL)
LOWER ADJUSTING
STUD & NUT!
VENTILATOR
IVISION CHANNEL
LOWER ADJUSTING
STUD & NUT
INNER PANEL
CAM SCREWS
1055
FRONT DOOR WINDOW ASSEMBLY-
"B-l 1-35-45-69" Styles
The front door window assembly consists of a
frameless piece of solid tempered safety plate
glass pressed into a thin section lower sash chan-
nel. When cycled, the glass operates within the
ventilator division channel and window glass run
channel (Fig. 6-33).
Removal and Installation
1. Remove door trim assembly and inner panel
water deflector.
2. Remove front door ventilator as described in a
preceding procedure.
3. Loosen window glass run channel lower ad-
justing stud nut (Fig. 6-65).
4. Remove inner panel cam as described in a
preceding procedure.
5. Slide window lower sash channel cam off win-
dow regulator lift arm and balance arm rollers
and remove window outboard of door upper
frame.
Fig. 6-87— Front Door Hardware - " Z "
Styles
FRONT DOOR WINDOW
ADJUSTMENTS-"B-11 -35-45 and 6 9 "
Styles
Adjustments have been provided to relieve a binding
door glass due to misalignment of the glass run
channels. The glass can also be adjusted to correct
a rotated (cocked) door window assembly. To per-
form the following adjustments, remove door trim
assembly and detach inner panel water deflector,
where necessary, to gain access to the hardware
attaching points.
Adjustments
1. To adjust lower portion of ventilator division
channel for proper alignment with door window
assembly, lower door window and loosen ven-
tilator adjusting stud nut. Turn adjusting stud
in or out or position lower end of channel fore
or aft as required; then tighten adjusting stud
nut (Fig. 6-65).
2. To adjust lower section of door window rear
glass run channel in-or-out for proper align-
ment with door window, first lower door win-
dow. Then, loosen rear run channel lower
Advertisement
