Advertisement
7-4
REAR QUARTER
REAR QUARTER W I N D O W -
" X - l l " Style
Removal and Installation
1. Remove rear quarter trim assembly and inner
panel water deflector.
2. Remove glass run channel inner and outer strip
assemblies (at belt). Refer to index of "Door"
section for removal procedure.
3. With window in the full up position, remove
window support to regulator plate attaching
screws (Fig. 7-18).
4. Operate window regulator down.
Disengage
window assembly from regulator arm and tilt
rear of window downward to disengage window
from glass run channels. Lift/Window upward
and inboard and remove from body.
5. To install, reverse removal procedure.
REAR QUARTER WINDOW
ADJUSTMENTS-"/" Closed Styles
For proper operation of rear quarter window and
correct seating of glass in run channels, adjust
rear quarter window in the following sequence:
1. With the window in the full "up" position,
loosen the window support to regulator plate
attaching screws and the center guide attaching
screws.
2. Using hand pressure, press window upward and
forward to make certain it is "bottomed" in
the upper and forward glass run channels.
3. Tighten window support to regulator plate at-
taching screws and center guide upper attach-
ing screw.
Fig. 7-5-Rear Quarter Hardware - " A - 1 7 " Style
1. Window Glass
2. Sash Channel Cam
3. Rear Guide
4. Up-Stop
5. Front Guide
6. Down-Stop
7. Window Regulator (Manual)
8. Window Regulator (Electric)
Advertisement
