Advertisement
6-36
DOORS
VENTILATOR TO CASTING
FRAME SCREW!
VENTILATOR
CASTING BOLT
VENTILATOR CASTIN
ADJUSTING STUD
AND NU
UPPER HINGE SCREW
LOWER HINGE SCREWS
Fig. 6-43 —Front Door Hinges and
Ventilator - " X " Styles
1. Adjustment provided at body hinge pillars:
Up or down on all body styles, in or out on "X"
and "Z" Body Styles and fore or aft on "A",
"A", "B & C" & "F" Body Styles.
2. Adjustment provided at door hinge pillars:
Fore or aft on "X" & "Z" Body Styles, in or
out on "A",
"B & C", "E" Si "F" Body
Styles and a slight amount of up or down on
"A", "B & C" & " F " Body Styles.
specifications in the "Front and Rear Door"
section of this manual.
FRONT DOOR INNER PANEL CAM
Removal and Installation
1. Remove door trim assembly and detach inner
panel water deflector.
2. With window in raised position, remove cam
attaching bolts ("1", Fig. 6-52) and slide cam
off regulator balance arm roller.
NOTE:
Figure depicts "B & C" styles - other
style similar.
3. To install, reverse removal procedure.
NOTE:
One end of the cam has provisions for
up and down adjustment to correct a "cocked"
window (not parallel with top of door upper
frame or side roof rail weatherstrip).
FRONT DOOR LOCK REMOTE CONTROL
AND CONNECTING ROD
The remote control is secured to the door inner
panel by three attaching bolts. On some styles the
remote is attached to the inboard surface of the
inner panel and on other styles, to the outboard
surface. The removal and installation is similar,
however, for either method of attachment (see
Figure 6-53).
When making door adjustments, refer to the
door gap spacing and lock striker engagement
UPPER HINGE
T O - D O O R
BOLTS
i LOWER HINGE
' T O - BODY
BOLTS
Fig. 6-44 —Front Door Hinges - " Z " Styles
Advertisement
