Advertisement
DOORS
6-61
1. Window Rear Guide
Bolts
2. Lower Sash Channel Cam
Attaching Screws
Fig. 6-83—Front Door Hardware - " F " Styles
3. Inner Panel Cam
Bolts
4. Regulator Bolts
5. Remote Control Bolts
6. Venti lator Division Channel
Lower Stud and Nut
7. Ventilator to Door Inner
Panel Screw
2. Remove front and rear door window up-travel
stops.
3. Lower door window and remove glass run
channel outer strip assembly (draft strip) as
explained in "Front and Rear Door" section of
this manual - see index.
4. With a screwdriver and a suitable flat-bladed
tool, remove sealing strip from door lock
pillar (see Fig. 6-82).
5. Remove screws (2) securing door window lower
sash channel cam to sash channel and remove
cam (see Fig. 6-83).
6. Pull glass straight up and remove from body.
7. To install, reverse removal procedure. Check
window for proper operation before installing
water deflector and trim assemblies.
Adjustments
Adjustments have been provided to correct any dis-
crepancy within glass alignment to achieve opera-
tional ease and effective seals. To perform the
following adjustments, remove door trim assembly
and detach (where necessary) inner panel water
deflector.
1. To adjust lower section of ventilator division
channel, for proper alignment to door window
assembly, lower door window and loosen ven-
tilator division channel lower adjusting stud
nut. Turn adjusting stud in or out and position
lower end of channel fore or aft as required
and retighten stud nut (see Fig. 6-83).
Advertisement
