Advertisement
TAIL GATE
9-9
ELECTRIC CONNECTION
JAMB SWITCH
VIEW A
1626
Fig. 9-15 — Tail Gate Jamb Switch
2. To install, reverse removal procedure.
Fig. 9-16-Tail Gate Inside Handle Attachment
TAIL GATE REMOTE CONTROL
INSIDE HANDLE
" B " STYLES
Removal and Installation
1. Raise inside handle and disengage remote push
rod from spring clip. (See Fig. 9-16).
2. Remove screws securing handle to inner panel
and remove handle.
3. To install, reverse removal procedure.
NOTE:
The inside handle on "A & X" Body
Styles is retained by a single attaching screw.
4. Remove remote control attaching bolts and
remove assembly from tail gate. On "B" Body
Styles, it will be necessary to disengage re-
mote from inside handle push rod. (See Fig.
9-17 for "X" Body Styles and Fig. 9-18 for
"B & A" Body Styles).
5. To install, reverse removal procedure.
NOTE:
The remote adjusting nut on "B" and
"A" Body Styles (Fig. 9-18) can be adjusted to
increase or decrease remote operating effort.
TAIL GATE LOCK ASSEMBLY-
RIGHT OR LEFT SIDE
TAIL GATE LOCK
REMOTE CONTROL ASSEMBLY
Removal and Installation
1. Remove tail gate window assembly.
2. Disconnect remote control to lock connecting
rods at remote assembly by sliding clip out of
engagement. (See Section "B-B" in Fig. 9-17).
3. On "X" Body Styles, remove remote control
inside handle attaching
screw
and remove
handle. (See View n in Fig. 9-17). Pry out and
remove escutcheon.
Removal and Installation
1. Remove tail gate window assembly.
2. Remove tail gate window lower glass run
channel on side from which lock is to be
removed.
3. Remove screws securing lock to tail gate.
(See Fig. 9-19).
4. Move lock assembly to tail gate access hole,
disengage remote rod anti-rattle clip and re-
move lock assembly.
5. To install, reverse removal procedure.
Advertisement
