Advertisement
REAR COMPARTMENT LID
8-11
BELL C R A N K
SCREWS
ECHANICAL
PULL - DOWN
NIT
LOCK
ATTACHING
BOLTS
CONNECTOR
Fig. 8-22—Rear Compartment Electric Release Unit
3. Disconnect electric feed wire at connector.
4. Remove lock and electric release assembly.
5. To install, reverse removal procedure.
Fig. 8-21 —Mechanical Pull-Down Unit Hydraulic Cylinder
REAR COMPARTMENT LID LOCK
ELECTRIC RELEASE U N I T -
Pontiac "A & B" Option
Rear compartment lid lock electric release unit
option on Pontiac "A & B" Styles is a side-action
snap-bolt type lock with an electric release unit
attached. The release unit is controlled by a switch
located in the instrument panel compartment box.
As this is only an unlocking feature, the rear com-
partment lid must be closed manually.
REAR COMPARTMENT LID LOCK
ELECTRIC RELEASE OPTION
Removal and Installation
1. Open rear compartment lid. Remove rear
compartment lid lock cylinder and shaft as
previously described.
2. Remove bolts securing rear compartment lid
lock assembly to rear compartment lid anchor
plate (Fig. 8.22).
REAR COMPARTMENT WEATHERSTRIP-
AM Styles
Removal
1. Separate "butt" ends of weatherstrip at rear
compartment opening (Fig. 8-23).
2. Using a flat-bladed tool, carefully disengage
weatherstrip from its cemented foundation in
gutter completely around opening and remove
weatherstrip from body.
SECTION B-B
GUTTER
CEMENT
( PRIOR TO
WEATHERSTRIP
INSTALLATION )
EATHERSTRI
'
CEMENT
( AFTER
WEATHERSTRIP
BUTT JOINT
INSTALLATION
VIEW C
Fig. 8-23—Rear Compartment Weatherstrip Assembly
Advertisement
