Advertisement
DOOR, QUARTER AND SHELF TRIM
14-3
HANGER PLATE SCREWS
ARM REST SCREWS
TRIM PAD SCREWS
VIEW A
RETAINER
SEALING PLUG
VIEW B
2476
Fig. 14-6-Door Trim Assembly - " F " Body 12600 Series
2. Push tool to disengage handle retaining spring
from spindle and remove bearing plate and
handle from door.
3. To install, engage retaining spring on handle
and position handle to door at same angle as
opposite side door handle; then, press handle
until spring engages spindle.
To remove "paddle'
follows:
type door handles, proceed as
1. On styles with "applied'
;
type door arm rests
as shown in Figure 14-4, Section "C-C", re-
move arm rest as previously described. Then,
remove screw securing handle to remote con-
trol spindle and remove handle.
On all styles, except 12600, with arm rests
that are a component part of the door trim as-
sembly as shown in Figure 14-5, it is neces-
sary to remove remote control cover plate
(Fig. 14-9 and view "A", Fig. 14-3) to gain
access to remote handle screw. On 12600
Styles, remote handle can be removed with a
hex-head wrench and is accessible with all
trim intact (Cover Plate is not utilized on
12600 Styles).
NOTE:
On styles with dual remote control
handles, remove cover plate to gain access to
Advertisement
