Advertisement
9-4
TAIL GATE
Fig. 9-6 —Tail Gate Hardware - " B " Body Styles
1. Outside Handle or Key Switch
2. Sash Channel Cams
3. Locks
4. Lower Glass Run Channels
5. Inside Handle
6. Torque Rod
7. Remote Control Connecting Rods
8. Remote Control
9. Regulator
10. Anti-Rattle Clip
11. Inside Handle Push Rod
2. Operate tail gate window to a point that sash
channel cam attaching bolts are accessible as
depicted in Figure 9-10.
NOTE:
On styles equipped with power oper-
ated tail gate windows, engage jamb switch and
operate window to any position desired. En-
gaging the tail gate jamb switch, makes it
possible to operate the window (by key switch)
with gate in the lowered position. This jamb
switch is located on the left side of the tail
gate on "B" Bodies and the right side for "A
& X" Bodies. "B & A" Bodies have a switch
of similar design that can be engaged by mere-
ly pushing arm with a finger. (See Fig. 9-5).
On "X" Bodies, however, the jamb switch
consists of two contact plates, one on gate
and one on body pillar. These plates can be
engaged with gate open by connecting them
with a length of body wire. (See Fig. 9-11).
3. Remove right and left cam attaching bolts
(Fig. 9-10). Slide cams sideways to disengage
from regulator lift arm rollers and remove
cams from tail gate.
4. Pull window straight out to remove from tail
gate.
5. To install, reverse removal procedure.
Adjustments
The tail gate glass run channels can be adjusted to
relieve a binding glass. To correct a rotated glass
condition, loosen window regulator attaching screws
and rotate regulator clockwise or counter clock-
wise as required.
Advertisement
